1.When commissioning , set start delay time(D-Time knob)to known motor run-up time , or to the maximum, if not known.
接入电机回路后，根据电机实际启动时间设置启动延迟时间（D-时间旋钮），不知道时设置为最大。
2.During burning, the fuel segments get thinner and thinner, sometimes breaking off, which makes the motor run rough or even become unstable.
而燃料块在燃烧的时候会变得越来越薄，有时候还会散落开来，使得马达运转不顺，甚至变得不稳定。
3.When the motor is already started , we let the power takeoff engage , and let the motor run with low speed to fully pre-heat .
发动机启动后，啮合取力器，并使发动机低速运行，以便充分预热。
4.Supply oil in the hydraulic device to the hydraulic slave motor to make the hydraulic slave motor run and generate power.
将液压装置中的油供给液压马达，使液压马达运转发电。
5.As we all know, DC motor run time does not allow loss of field, or will have a runaway accident.
众所周知，直流电动机运行时不允许失磁，否则将产生飞车事故。
6.We can't have the motor run idle.
（同上）我们不能让马达空转。
7.We chose the MELSERVO-MR-J2 to make up the servo system, we use impulse control, it can make the motor run more accurately.
伺服系统则选用三菱电机的伺服系统MR-J2，使用脉冲控制，可以是电机进行精确定位。
8.MKP Polypropylene film capacitor-AC Motor run application
MKP系列聚丙烯薄膜交流马达运转电容